High Temperature Resistant Sculpt Grey and Clear TDS
1. Product Introduction
The High-Temperature Resistant Sculpt series includes three colors: Grey, Clear and Ultra White
Grey and Clear are regular versions of Sculpt Series.
Key Features
Sculpt Grey and Clear combine high resolution and low shrinkage to deliver the exact tolerances needed for accurate functional prototypes. Built for extreme environments, these engineering resins boast strong chemical resistance and can withstand high temperatures up to 180°C
Application:
- Low-run injection molds
- Vacuum forming
- Dental Application
- Artistic sculptures
- Designed for vulcanized rubber process
Check out Sculpt High Temperature Resin here.
2. Property Data
|
Mechanical Properties |
Measure |
Method |
|
Tensile Stress at Yield (Mpa) |
39 |
ASTM D638 |
|
Tensile Stress at Break (%) |
35 |
ASTM D638 |
|
Young’s Modulus (MPa) |
3500 |
ASTM D638 |
|
Elongation at Break(%) |
5 |
ASTM D638 |
|
Flexural Modulus (Mpa) |
3300 |
ASTM D790 |
|
Flexural Stress at Yield (MPa) |
40 |
ASTM D790 |
|
Flexural Strain at Break(MPa) |
1.2 |
ASTM D790 |
|
Other Properties |
Measure |
Method |
|
HDT at 0.455 MPa |
160 |
ASTM D648 |
|
Shore Hardness (D) |
90D |
ASTM D2240 |
|
Solid Density g/cm3 |
1.2 |
ASTM 792 |
|
Water Absorption (24hr) |
0.50% |
ASTM D570 |
|
Refractive index (For Clear only) |
1.5 |
ASTM D648 |
|
Liquid Properties |
Measure |
Method |
|
Viscosity at 25°C (77°F) |
650 |
ASTM D7867 |
|
Liquid Density |
1.13 |
ASTM D1475 |
3. Work Flow
- Clean
|
Cleaning Step / Category |
Instructions & Recommendations |
|
Cleaning Solvents |
• Preferred: 95% concentrated Ethanol or IPA. • Alternative: Methanol (must not contain acetone). |
|
Cleaning Time |
Submerge parts in the solvents for 2-3 minutes, using the ultrasonic cleaner. |
|
Submersion Limit |
Do not submerge parts in alcohol for more than 5 minutes. |
|
Extra Step |
For a complex model, use a painter brush (or any brush made with hair) to gently remove excess resin from the printed part. |
- Drying
|
Drying |
Remove alcohol by using an oven for 7-8 minutes (using a hair dryer requires 10 minutes) |
|
Note: For complex parts with cavities, repeat the clean/dry cycle multiple times. |
|
|
Quality Check |
Touch the dried surface. If it is still sticky, wash and dry the part again until smooth. |
- Post-Curing
|
Step / Factor |
Instructions & Recommendations |
|
Preparation |
Ensure the resin is completely cleaned off and absolutely no alcohol is left on the print before curing. |
|
UV Specifications |
Use a UV light source with a wavelength of 395-405nm. |
|
Curing Time |
Cure for approximately 15 minutes to reach optimal strength. Parts must be fully cured before use. |
|
Recommended Method |
Direct curing without water for moisture control. |
More information：
Check out Sculpt Resin User Guide
Download Sculpt Resin TDS in PDF Version