ABS-like Fast Resin TDS | For Basic Fast

This TDS is for Fast Creamy/Grey/White/Navy Grey/Green/Metal Grey/Smoky Black.

Other information you might also need:

1. Product Introduction

Good fluidity for faster printing and a higher success rate
Tough and not fragile, can withstand accidental falls
Easy to clean, reducing printing time
Excellent detail, precise printing

Application:

Great for general printing
Tabletop miniatures
Digital sculptures
Model Making

2. Property Data

Mechanical Properties	Measure	Method
Tensile Stress at Yield (Mpa)	64	ASTM D638
Tensile Stress at Break (%)	60	ASTM D638
Young’s Modulus (Mpa)	1700	ASTM D638
Elongation at Break (%)	18	ASTM D638
Flexural Modulus (Mpa)	2400	ASTM D790
IZOD Impact (Notched) J	25	ASTM D256
Shore Hardness D	75	ASTM D2240

Other Properties	Measure	Method
HDT at 0.455 MPa	65	ASTM D648
Solid Density (g/cm3)	1.2	ASTM 792
Water Absorption (24hr) (%)	0.75%	ASTM D570

Liquid Properties	Measure	Method
Viscosity at 25°C (77°F)	110	ASTM D7867
Liquid Density	1.1	ASTM D1475

3. Work Flow

Printing

Fast Resin by Siraya Tech is a premium 3D printing material that offers fast printing and curing times, low odor, and easy cleaning. With high precision and detail retention, it's ideal for intricate designs. Perfect for prototyping and production, it's a top choice for hobbyists, artists, and beginners alike.

Fast Navy Grey requires 20% more exposure time than other regular Fast.

Fast Navy Grey and Fast Creamy have heavy pigments for a smooth matte look. Shake hard before opening to prevent white clusters from settling.

To achieve optimal results with Fast ABS-Like resin, you need to use the appropriate slicer profiles for your printer model and software. You can download the slicer profiles for Chitubox and Lychee slicers from this link: 3D Printing resin setting profile

Get started with the Siraya Tech V5 test model: Download the free Siraya Tech 3D printable test model here

Clean

Cleaning Step / Category	Instructions & Recommendations
Cleaning Solvents	• Preferred: 95% concentrated Ethanol or IPA. • Alternative: Methanol (must not contain acetone).
Cleaning Solvents
Cleaning Time	Submerge parts in the solvents for 3-4 minutes, using the ultrasonic cleaner.
Extra Step	For complex model, use a painter brush (or any brush made with hair) to gently remove excess resin from the printed part.

Drying

Drying	Remove alcohol by using an oven for 4-5 minutes (Or using a hair dryer requires 10 minutes at least)

	Note: For complex parts with cavities, repeat the clean/dry cycle multiple times.
Quality Check	Touch the dried surface. If it is still sticky, wash and dry the part again until smooth.

Post Curing

Step / Factor	Instructions & Recommendations
Pre-curing Checklist	Ensure the part is completely clean of excess resin and fully dry (no alcohol left) before starting.
UV Specifications	Use a UV light source with a wavelength of 395-405nm.
Curing Time	Cure for approximately 1-2 minutes to achieve optimal strength.